Maori question

W.A.L.T say questions in Maori so i made this slide to show you some of the questions.It was really challenging getting all the animated kids on the post.Hope you enjoy😎😎

measurements

W.A.L.T measure how big objects are in the classroom.

it was really hard measuring the tables and the door.

halloween jayden

W.A.L.T: Make a google drawing about should we keep Halloween our ban Halloween.

I Think it was very fun making this because there was lost of cool pictures and Halloween fonts.I think it was trying to get my DLO onto my blog.

Te kauru camp 2018 - (writing 2nd draft)

(INVADER).

Me my Dad Nate and Dan were the only four from our group to go on as Kordal got motion sick and Ethan was not keen.Here we go it slowly started spinning then it had a little more power then suddenly who-ff,swish screams from everyone my screams were probably the loudest.Me and Nate were begging for one more time YES Dad said.here we go again who-ff,swish air was filling up my lungs as I open my mouth. THAT WAS THE BEST!!

the invader was my personal favorite😆This was us on the stratosphere. It wasn't that scary.😑

The roller coaster upside down felt like falling out off a plane😱

My STEAM reflection

 
STEAM - TERM 3
- Coding (Snap4Arduino) and Arduino Boards
In Term 3, the students have been continuing their STEAM learning using the STEAM Electronics kits. They have been learning how to block code using the program Snap4Arduino. The purpose of this learning has been for the students to control one or more LED lights on an electronic arduino board using code. Each week the coding expectation increased and the students showed perseverance in achieving successful outcomes!
Learning Goal 1. To make an LED blink off/on by controlling voltage from 0V to 5V by programming the Arduino.
Learning Goal 2.  To change the speed of blinking to such a high rate that the LED appears to be dimmer.
Learning Goal 3. To make the LED fade on and off by varying the voltage



2018 - Term 3 STEAM - ‘Coding and Arduino Boards’ Reflective Questions


1.was I learning and why?
In whaea debs steam hub we were learning to make 1 or more leds flash.we also learnt how to put the wires in the right places and how to code.

2.What did I do well and how do I know?
i think i was really good at doing the codes to make the led blink.It was very easy to put the code in.

3.What challenged me ……?
my challenge was trying to make 3 LED shine.It was very hard doing the wiring especially when the intructions are muddle up.

4.What would I do differently next time to make my learning more successful ….. ?
I think i would make sure all the wires were in the right places.so that the led would be a little bit brighter and we would be more successful.

5.What have I enjoyed about the learning?
 I enjoyed making the led shine as well as as having my partner there to help me.It was even better when we got two working.

my quality blog comment tips

These are my tips on how to make a quality blog comment. we learnt them from watching this video from the manaiakalani crew.

My book review